Toggle Switch with suffix “K”

We have produced a toggle switch for all types of our solar
ventilators with suffix “K” as their product number. Such as
SVT-012K means SVT-012 with an On/Off Switch at the bottom
of the vent outside the mesh.

After the installation is completed, set the switch at “on” and if the
user want to Stop the operation of ventilation, just set the switch
at “off”. Purpose of the toggle switch is to cut off the circuit while
the ventilator is not being used.

Remote on/off Switch with suffix “R”

All of our solar ventilators can be designed with remote On/Off
controlled switch with suffix “R” as their product number. The wires
can be 2.5 meters away from the installed ventilator. Purpose of
remote on/off switch is to cut off the circuit more easily while the
ventilator is not being used.

Separated Solar Panel with suffix “A”

All of our solar ventilators can be designed with separated solar panel
with suffix “R” as their product number. The solar panel with its
mounting rack is to be connected with the attached 4.8 meters of wire
which enable the solar panel can be installed a distance of around 5 meters
away from the ventilator.

The mounting rack is made of ABS Plastic which is durable and safety.
The white color is designed to be minimized of heat absorbed under
the hot sun. With the aid of supplied stainless steel screws. The holder
can be mounted to an angle of 45 degree or 30 degree from its vertical.
The mounting place is best to be most shinny area near the installed vent.
Face to the sun and ensure the solar cells can absorb the most sunlight
which the vent can receive the better efficiency.

The solar panel should be faced up to the sun (not to the ground).
In this installation, the vent can be mounted at any area even without
sunlight.

The wire between the panel and the vent is plastic sealed, and can be water
resistant with no problem. At the wire ends we have added the heat melted
plastic tube to seal the wire ends completely..